Arhivă — Seria D

Combined Heat & Power Industrial Plants with gas turbines & heat recovery steam generators – Feasibility study method and case analysis

Aspects of using hydrogen in SI engine

CO2 capture from post-combustion gas by employing MEA absorption process – Experimental investigations for pilot studies

Variable speed pump-turbines technology

Numerical investigation of the 3D flow in the suction elbow and impeller of a storage pump

Analysis of operating parameters during normal and transient regimes of a high head Hydro Power Plant

Vibrations level analysis during the operation of a high head Hydro Power Plant

Aerodynamic geometry optimization of a centrifugal blower

Evaluating the lifetime of hydro-mechanical equipment for low head Hydro Power Plants

Numerical simulation of the flow in the draft tube of the Kaplan turbine

HBMOA applied to design a water distribution network for a town of 50000 inhabitants

Chlorine concentration decay in the water distribution system of a town with 50000 inhabitants

Measurement technique for air-water disperse system study

Some applications require knowledge of simultaneity of two-phase flow characteristics: liquid and gaseous. In case of a bubble column, for its complete characterization is necessary to determine the flow velocity induced by the column of bubbles in the liquid phase, the bubble ascension velocity, and bubble characteris…

The influence of the velocity induced by an aeration grid upon oxygen transfer

Management of a hydroelectric mobile dam

Determination of difficult to measure nuclides in spent resins

Study of fluid-structure interaction in liquid droplet impingement phenomena

Experimental determination of the mechanical compression strength for CANDU type experimental fuel bundle

Study on the main factors influencing human performance in NPP operation

Core neutronic effects at the use of burnable absorbers in CANDU fuel bundles

The assessment of a new technology used for the treatment of petroleum contaminated soils - Laboratory study

Sustainable energy in wastewater treatment plants

Deposition near a sintering plant: Preliminary comparison between two methods of measurements by deposimeters

Role of feedstock transport in the balance of primary PM emissions in two case-studies: RMSW incineration vs. sintering plant

Study on Stanca-Costesti Lake eutrophication process – Causes, effects and management solutions

Mathematical modeling of Sharon biological wastewater treatment process